RRC[

Rat Rig Community [Unofficial]•13mo ago•

7 replies

plargent

RatOS for Raspberry Pi5 ?

I have a working Ratos/rPi/Klipper running on a rPi 4.
I plan to replace the rPi 4 with a new rPi 5 8GB
The printer is a VCore3.1
I went to https://github.com/Rat-OS/RatOS/releases and downloaded the latest (2024-07-27 RatOS-v2.10-RC2) image file.
The file was '2024-07-27-RatOS-2.1.0-RC2-raspberry-rpi32.img.xz'
When the SD card is booted on the rPi 5 I get the following error:
The installed operating system (OS) does not indicate support for Raspberry Pi 5
Update the the OS or set os_check=0 in config.txt to skip this check.***
Before I start modifying the OS or boot procedures, I wanted to check:
Q. Does RatOS supports rPi 5?
Q. Did I downloaded the right file? (should I have gone with armbian-CB1 over raspberry-rpi32?)
Q. Should I be using Release Candidate 2.1 or one of the earlier releases?
Any help will be appreciated.

GitHub

Releases · Rat-OS/RatOS

The preconfigured Raspberry Pi image that makes it easy to run Klipper + Moonraker + Mainsail on your printer. - Rat-OS/RatOS

Solution

Jump to solution