![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
VC4 500 Good enough to install hybrid belts?
Hi all,
I've recently finished up a VC4 500 and got the attached response and shaper graphs.
In my opinion, these look to be good enough for me except for some leftover resonance in the 100-135Hz range and close to 200Hz. I left an inch of belt on both sides of the toolhead (in case anything goes wrong) so I have a feeling those are the causing the resonance. I would prefer not mess with the base core xy belts anymore since things like this can begin to spiral out of control.
But since this is my first printer build I would prefer to hear some more experienced opinions before I lock in the hybrid belts.
Thank you for reading
I've recently finished up a VC4 500 and got the attached response and shaper graphs.
In my opinion, these look to be good enough for me except for some leftover resonance in the 100-135Hz range and close to 200Hz. I left an inch of belt on both sides of the toolhead (in case anything goes wrong) so I have a feeling those are the causing the resonance. I would prefer not mess with the base core xy belts anymore since things like this can begin to spiral out of control.
But since this is my first printer build I would prefer to hear some more experienced opinions before I lock in the hybrid belts.
Thank you for reading
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,034Members
Resources
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}