![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
Print to squished on 1 side & loose on the other
Recently I have noticed that the 1st layer on my print is really bad. You can see from the photo that it is squished too much on the left but the lines are not even touching on the right causing it to lift off the bed.
I am using RatOS with the default Start_Print sequence & a beacon surface scanner & the height map does not look too bad either.
I did all the calibration steps for the beacon too but with PLA. I thought that it compensated itself for the higher ABS temperature.
Any suggestions?
I am using RatOS with the default Start_Print sequence & a beacon surface scanner & the height map does not look too bad either.
I did all the calibration steps for the beacon too but with PLA. I thought that it compensated itself for the higher ABS temperature.
Any suggestions?
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,034Members
Resources
Recent Announcements
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}