Vcore 3.1 400 after beacon configuration
Z-tilt done several times yet the bed mesh looks like Z1 is off by 1mm. BEACON_CREATE_SCAN_COMPENSATION_MESH created the contact bed mesh profile which looks identical. I rotated the build plate by 90 deg and it's still the same (pictured). I verified the stepper motors via buzz as well.

7 Replies

I think I found the problem but I don't know how to fix it yet. At z1 the beacon misses the PEI plate and registers off the build plate instead. I need to change the Z-tilt measuring locations somehow
I added the following lines to printer.cfg and it seemed to fix the z-tilt probing the wrong areas. However, now I'm getting an error when doing a bed mesh "move out of range"

Update: I removed the beacon y_offset and added bed mesh min and bed mesh max to [bed_mesh] as well as increased the probing points for good measure.


How would i translate this to my printer ?
mine is 500 mm
points:
40,30
250, 450
460,30