![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
Merc 1 Hydra RatOs 2.1
I have a odd issue and for the life of me i cannot figure it out, printer was working great but hated the toolhead so i swapped it out to a stealthburner with bambu hotend, did the calibrations for new toolhead beacon heightmap all that stuff, all worked fine, sliced a test cube sent to printer it does its things z tilt, etc but right before it does the adaptive mesh it moves to front left corner and slams into the front profile, then it slowly does a moonwalk to the right likes its doing a purge line but it does nothing, then it moves to right corner then does the scan and back to right corner and does the blob, and prints perfect, i cannot get it to stop slamming into the front rail. i did no changes other than toolhead , i have sized down the bed mesh a lot still does it. has the frabreeko 400mm bed, using orca slicer and copy n paste gcode from ratos set up, nothing added to it
[bed_mesh]
horizontal_move_z: 25
mesh_min: 20,80
mesh_max:365,345
probe_count: 7,7
fade_start: 1.0
fade_end: 10.0
mesh_pps: 2,2
algorithm: bicubic
bicubic_tension: .2
[z_tilt]
0, 45 #stepper_z Mini Tank
190, 360 #stepper_z1 Mini Tank
365, 33 #stepper_z2 Mini Tank
points:
65,100 #probe location front left
190,360 #probe location rear middle
325,55
[bed_mesh]
horizontal_move_z: 25
mesh_min: 20,80
mesh_max:365,345
probe_count: 7,7
fade_start: 1.0
fade_end: 10.0
mesh_pps: 2,2
algorithm: bicubic
bicubic_tension: .2
[z_tilt]
Use Z_TILT_ADJUST to level the bed
z_positions: Location of toolhead
z_positions:0, 45 #stepper_z Mini Tank
190, 360 #stepper_z1 Mini Tank
365, 33 #stepper_z2 Mini Tank
points:
65,100 #probe location front left
190,360 #probe location rear middle
325,55
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,070Members
Resources
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}