Printing paused or how to disable clog detection
Hello everyone,
I'm currently trying to print the skew_calibration but am already failing to do so. When I start the printing it pauses randomly, sometimes after a few lines or right after the prime blob. I recognized that the sensor flashes yellow briefly before changing to green and then pausing. When I force him to continue he unloads the filament.
I enabled debug and it seems to be the clog detection. I tried to disable it in the printer config. but it has no effect.
Did I do something wrong or is there any other possibility do disable it.
I would be very grateful, if you could help me
3 Replies
I keep having this same issue, did you find a fix for this?
This is generally a problem with the filament feed path, there is too much back-tension on the filament, and the filament runout sensor is tripping the tangle detection (yellow flashing). You can go into the printer.cfg and temporarily disable the tangle detection until you get the filament path sorted out so that the filament pulls through easier.
I only had these problems with large 2.5 kg rolls. I disconnected the cable and then it worked even when the sensor was activated.