![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
IDEX Underextrusion
Anyone else seen this issue? VC4 500 IDEX setup and overall print looks good, except for pretty bad Underextrusion in areas of the print where the amount of filament laid down is relatively small...even with 1.0 extrusion multipliers, dry filament, reasonably fast speeds (300-450), and PA completely disabled. It's as though I'm losing nozzle pressure during the time it's parked and so it takes a little while to recover with proper flow. Thoughts??
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,070Members
Resources
Recent Announcements
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}