Servo Motor Not Working Correctly
Hi, after connecting the servo motor to VCC (5V), GND and a digital pin, I tried running an example on Arduino but it does not provide a continuous rotation.
In the video you will see that it rotates a bit and then stops. I then reset it and it spins a bit and stops again. Since the power is cut off during the reset, it makes a small turn again and does not continue.
I would like to clarify a bit: I know it is 180 degrees, there is no problem in the code, the default example provided by Arduino and the pins are connected correctly.
In the video you will see that it rotates a bit and then stops. I then reset it and it spins a bit and stops again. Since the power is cut off during the reset, it makes a small turn again and does not continue.
I would like to clarify a bit: I know it is 180 degrees, there is no problem in the code, the default example provided by Arduino and the pins are connected correctly.
