![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
All Prints too small in Z
All my Prints are too small Z. A 50x50x20mm part comes out as 50,05x50,05x19,45.
I use Orcaslicer but i already tried Prusaslicer for a while (without any success)
The printer has 0.6mm nozzles installed right now. I just redid beacon calibration again at 85c bed and 35c chamber. Same with VAOC Thermal Expansion.
I didnt touch z-offset because as far as i know thats the point of beacon contact?
Frist layer is ok but it a bit on the high side so there is some gaps. All other solid layers are filled perfectly.
Any ideas?
I use Orcaslicer but i already tried Prusaslicer for a while (without any success)
The printer has 0.6mm nozzles installed right now. I just redid beacon calibration again at 85c bed and 35c chamber. Same with VAOC Thermal Expansion.
I didnt touch z-offset because as far as i know thats the point of beacon contact?
Frist layer is ok but it a bit on the high side so there is some gaps. All other solid layers are filled perfectly.
Any ideas?
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,070Members
Resources
Recent Announcements
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}