TMC Stepper_z2 reports error DRV_Status during beacon calibration

VC4-400 mm build. Build is finished for the Core XY kit. I have passed the sanity checks and checked all my wiring a few times now. When I attempt a ( beacon calibration ) it starts its sequence and before finishing I lose connection to klipper due to this error. Over temp warning for the z2 stepper. Here’s some photos for reference of my wiring lol be easy on the roasting. This is my first build and I learned a lot during this. Any ideas to try or Solutions would be appreciated please and thank you!

Solution

I figured it out. If your fan is not spinning during operations it’s configured wrong. I chose digital pwn on 2 pin port for the controller fan which I’ve been referring to it as the mcu fan. I have changed it to input voltage pwm on the configurator and can verify my fans are working during operations now.

Jump to solution