![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
VC4 Hybrid not recognizing filament runout
Has anyone ran into an issue where their Orbiter Smart Sensor doesn't stop prints when filament runs out?
I just installed this a few days ago. I followed ratrig.dozuki.com guide so I know it's hooked up to the canbus correctly.
I also added the changes to the printer.cfg so it shows up in ratos and shows activated/detected. But when filament runs out the printer continues on printing.
Any thoughts?
I just installed this a few days ago. I followed ratrig.dozuki.com guide so I know it's hooked up to the canbus correctly.
I also added the changes to the printer.cfg so it shows up in ratos and shows activated/detected. But when filament runs out the printer continues on printing.
Any thoughts?
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,034Members
Resources
Recent Announcements
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}