USB-C connection poor
I have recently ordered and built a lily58 with the no-solder hotswap and nice!nano controllers. I have not had any issues with the board until recently. The T and G keys on the left half are unresponsive or input twice unless my USB connection is plugged in a certain angle with a certain amount of pressure. I am constantly required to push the cable into the microcontroller (every 10 seconds) or else I cannot get input from the T or G key. The rest of the left half works fine
1 Reply
It sounds like you might have an issue with the USB-C port on your nice!nano. Since you're using the no-solder headers, you can easily remove the nice!nano to inspect the port.
Check for any debris in the port or if the port itself seems loose or damaged. If you have another USB-C cable, try using that to see if the issue persists.
If the port appears damaged or the issue continues with a different cable, the nice!nano itself might be faulty. Since you used no-solder headers, you can easily swap it out with a new one.
If you need further assistance, feel free to reply to this message or tag me.