Vcore - 4 500 - IDEX the pause starts itself
Hi, I created the settings according to ratrig wifi, I didn't change anything anywhere and I have several problems. Sometimes a pause is executed independently, in the console there is no reason why the pause was triggered. When I put resume it goes, but again a piece of the perimeter is skipped. About twice it happened to me that when resuming after a pause it said the print was done, when it had about 10% of the print done. Once I turn off the filament sensors it is ok. Since I communicated with chatgpt he said there is some sort of pause cycle but what the truth of that is I don't know. Another thing is that when I push the button to load the filament it pushes the plastic into the rubber mat that is under the nozzle on the X axis to keep the filament from flowing out, is there any possibility of it going somewhere to the side when I push the button to load the filament ? It seems to me that overall the RATOS is not well thought out, but I probably can't switch to a pure clipper because of the IDEX
0 Replies