Help with gantry alignment
I recently got the Toro tube, and now every time I tighten the belts the alignment goes off, I used GATS and didnt have this problem with the original x axis, does anyone have a way to fix this?
6 Replies
Anyone?
Have you re-done the gantry alignment steps from the build guide?
I have
And it aligns perfectly until I tighten it
I'm going to try a different xy joiner as I think the tube is slightly too long
Both belts need to be tightened to the same tension or else uneven forces will cause that to happen.
They are at the same tension, i was using gats with the same weight on each side
Are you taking your Y belts off when you tension your X belts?