Rat Rig Community [Unofficial]•2mo ago

'extras.resonance_tester' has no attribute 'VibrationPulseTest'

Getting the same error as here with a fresh install of ratos 2.1 https://www.answeroverflow.com/m/1316811318279278622 Migrated from 2.0 and this is a new thing I never had before. Adxl was working fine before, no errors during the configuration or install.

Clean RatOS 2.1 install, Error after update - Rat Rig Community [Un...

I'm getting the following Klipper error on a clean install: Internal error during connect: module 'extras.resonance_tester' has no attribute 'VibrationPulseTest' Once the underlying issue is corrected, use the "RESTART" command to reload the config and restart the host software. Printer is halted Do I need to downgrade my klipper, is somethin...

5 Replies

TheTik•2mo ago

doing a hard reset/recovery can break things, this is the recommended procedure currently:

1. Flash image
2. Connect to hotspot
3. Setup wifi through configurator (and let it reboot)
4. Go to /config
5. Refresh update manager
6. at this point nothing should be invalid, all green. IF THAT'S NOT THE CASE stop here and post your moonraker.log
7. Update only the RatOS package(NOT configurator).
8. Update RatOS configurator (this takes awhile, if the mainsail output of the update process hangs, let it sit for 10 minutes and then refresh the page, Ctrl+Shift+R)
9. Restart moonraker service (click power icon in the top right of mainsail, click the refresh button next to moonraker under "service controls")
10. Reload mainsail (Ctrol+Shift+R)
11. Refresh update manager
12. "RatOS" should be gone from the list. Everything should be green and have several updates except RatOS configurator (ignore the klipper errors). If it's not, stop here and post your moonraker.log.
13. Click update all.
14. Done.

1. Flash image
2. Connect to hotspot
3. Setup wifi through configurator (and let it reboot)
4. Go to /config
5. Refresh update manager
6. at this point nothing should be invalid, all green. IF THAT'S NOT THE CASE stop here and post your moonraker.log
7. Update only the RatOS package(NOT configurator).
8. Update RatOS configurator (this takes awhile, if the mainsail output of the update process hangs, let it sit for 10 minutes and then refresh the page, Ctrl+Shift+R)
9. Restart moonraker service (click power icon in the top right of mainsail, click the refresh button next to moonraker under "service controls")
10. Reload mainsail (Ctrol+Shift+R)
11. Refresh update manager
12. "RatOS" should be gone from the list. Everything should be green and have several updates except RatOS configurator (ignore the klipper errors). If it's not, stop here and post your moonraker.log.
13. Click update all.
14. Done.

atomikspaceOP•2mo ago

Ok I'll try again But honestly, pretty sure this was what I've done

TheTik•2mo ago

try again, and don't try to edit/import the old printer.cfg

atomikspaceOP•2mo ago

Its a bit late ill try again tomorrow. For reference, i was nowhere near editing the printer.cfg file. Thanks for the help!!

TheTik•2mo ago

no problem, and good luck!

Gaming

Programming

'extras.resonance_tester' has no attribute 'VibrationPulseTest'

Did you find this page helpful?