Help with RatOS for Pellet Extruder.
hi. i am building a pellet extruder with 3 heaters and 3 k type thermistor(using max6675) connected to octopus board using ratos. Since the thermal mass of the extruder is too much, it takes some time to heatup. But as soon as i heatup within a few seconds ratos stops with this error "Heater extruder not heating at expected rate". How can i go around this?
1 Reply
This is klipper making sure you don't burn your printer down. You have to PID tune it - https://www.klipper3d.org/Config_checks.html?h=pid#calibrate-pid-settings