V-CORE 4 COMMISSIONING GUIDE
V-CORE 4 COMMISSIONING GUIDE
Section:
SANITY CHECKS
Sub-Section:
Z Stepper motor directions
After Step 9 include the following:
Run the following command in your console:
SET_CENTER_KINEMATIC_POSITION
5 Replies
@Cruz ?
Hey! What about it?
did you see this? I had no time to check
I didn't, @Tiago can you communicate it internally?
I just checked.
It is correct but it should be after step 10.
Otherwise you can’t rotate the leadscrews by hand. After this, run the macro and follow to step 11 (that will be step 12).
If this is not included, you can’t move the bed via mainsail.
@Tiago , please, check this.