IDEX blobs
Im trying to dial in the IDEX and have some troubles..
I get these blobs on the sides of my test print, when switching T0/T1 - is there a way to tune this further?
Thanks a lot for any help! 🙏
4 Replies
use a small wipe tower in front or behind the print
Oh okay I thought Im supposed to rather not use wipe towers due to toolshift being fast enough?
Do you mean like this?
Would you recommend using z-hop or not?
I tested it with a small wipe tower like above, but now it eventually gets knocked off the plate; Should I use z-hop @ 0.6mm on each Toolhead?
hmm even with wipe tower I get some of these "blobs" 🤔 the rest looks pretty good I think though.
(the black blobs are partially from filament sensor pausing, but the cyan ones are from the wipe tower behind the print)
