![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
Change Toolshift during VAOC
Ok, so my issue is that I have a much smaller IDEX printer I've been working on building and I'm finally working on getting the IDEX part up and running. It is a roughly 200mm machine with dimensions that would be similar to a VC4 300mm, just 100mm less.
I've managed to adjust almost all the variables I need to run RatOS on a 200mm "VC4" machine, but during VAOC when switching toolheads, it clearly assumes I have more area in the X direction than I do. So when switching between T0 and T1, the toolheads hit the frame, skip steps, and result in VAOC tuning being impossible.
I'm terrible with coding, but I think I found the macro I need to change - [gcode_macro _VAOC_LOAD_TOOL]
I just can't figure out what to change with it. Anyone who can help?
I've managed to adjust almost all the variables I need to run RatOS on a 200mm "VC4" machine, but during VAOC when switching toolheads, it clearly assumes I have more area in the X direction than I do. So when switching between T0 and T1, the toolheads hit the frame, skip steps, and result in VAOC tuning being impossible.
I'm terrible with coding, but I think I found the macro I need to change - [gcode_macro _VAOC_LOAD_TOOL]
I just can't figure out what to change with it. Anyone who can help?
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,070Members
Resources
Recent Announcements
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}