Squaring the gantry
When I follow the ratrig procedure to square the gantry I end up with unequal belt tension and quite a notchy travel, when pushing the toolhead around by hand.
It moves pretty smooth with equal belt tension(frequency) but there is then some play in one side of the gantry.
Is there a way to square it without stripping the printer?
1 Reply
loosen all the belts and push it against the back. Both sides should be flush with the motor. If they are not, you have to loosen the bolts on each side (5 top, 2 bottom each side) and push again against the back. Tighten the bolts while flush