Extruder error
I keep getting this error and im uncertain of the reason I've checked all my cables and have made sure thag everything is connected properly.Not sure what this issue could be as it just keeps getting worse and worse. I can't even home as it give me the same error.
12 Replies
Pretty sure thats the extruder motor driver complaining. Are you using a toolboard?
Yes I am its using an ebb 42
Not a swappable driver then. Lemme google that specific error
Does the error happen immediately on booting up the machine, or does it happen mid-print?
Happens mid print and if I try to home it will just error out
Is there a heat sink on the driver chip?
Yes I have the provided heat sink for the board
Looked again and I infact did not have a heat sink reapplied one and it work better then before and errored out again same error, make me wonder if the driver chip is toast as I have ran extensive prints before.
Next troubleshooting step would be replacement anyways 😕. Good luck
Already ordered the board for kb3d btt46 1.2.1 apprerantly its better we will see.
Just replaced the board and it had the same error threw in a new orbiter ro see if that helps.
Ran it with the new extruder and had the same issue now im changing to a new USB cable again to see if that helps
After a new toolboard new wire fresh firmware install and new orbiter i still have the same issue i have no clue whats going on or why its doing this any advice?
Exact same error message?
If you disconnect the tool board do you still get that error?
I believe the issues has been resolved i recrimped a few wire that seem to have gotten loose over time and it seem to have fix it but only time will tell I was able to run a 5 hour print and an 11 hour print so hopefully its fixed thank you for all the help now I just got replacement parts if I need them 😂😂
Loose wires are the devil 😂
Yes they are