move out of range: 460.038
I attached what the rules had asked for.
so I homed , Z- tilt, then VAOC. Everything was dialed in. the print is within the build plate and ..... at layer three i get hit with this "move out of range" and the printer forced a cool down and I can not resume the print.
please explain this or a fix to this as if you are explaining to a child and i can fix this issue. Thank you in advance.
7 Replies
I don't have a VC4 nor IDEX, but have you made sure your macros are set up correctly? https://os.ratrig.com/docs/slicers#macros
Slicer Configuration | RatOS
- Prusa Slicer
my best guess is absolute vs relative positioning getting messed up, but I'm grasping at straws.
went through the commission guide and followed the steps, prusa slicer has all this setup exactly how the commission guide was showing already so i could not make any changes. Currently back to square one. Unfortunately.
for sanity purposes i ran this print again. at layer three when about to switch from active left tool head to the right tool had i get the mout out of range position.... but the right tool head is parked, as it should be. Not sure if this helps someone figure out what a fix can be with this information.
Even rotated the print 90 degrees and only got worse . Only printed the first layer with left tool head. Right tool head never exited the parked position.
re did commission guide for VOAC i keep trying and continue getting the error. This print is a Job that has a deadline and at this point idk how i can trust to ever use this printer for any future income.
Bump
New SD card with RatOS completeling following the commission guide and the members on face book gave me a hand and advised to not do the SKEW guide since they had issues with theird vcore 4 idex having the same issues i had. \