![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
Z offset fine in manual control, off during print
⚙️Configuration
Motion
Motiongot a little delta I've had sitting around half built for a year, finally getting around to setting it up.
decided to run RatOS for some reason, despite there not being a lot to gain for a machine like this.
When I z0 outside of a print my offset is perfect. my nozzle comes just into contact with the peaks of my testured PEI bed, it is reproducible how over many times I've tried. power cycled, cold motors, hot motors, tried it all, z offset remains perfect.
the problem is that if I'm actually in a print the nozzle says it is at my first layer height of .24mm, but the nozzle itself is physically +2mm off of the bed. Mainsail says .24, if I GET_POSITION I get .24, as far as I can tell the machine truly believes the nozzle is .24mm high and not the 2+mm it is in the real world.
My superslicer profile was build from scratch off of the generic. My Orca slicer profile is the delta flyer's with a few machine specs changed. I didn't have orca even installed on this machine before, so that is as fresh as it can be. same results with both slicers.
I've asked in the discord channel dedicated to this machine (some help, but no resolution yet) and the klipper discord help (no responses at all), so I'm really hopeful someone in here can help me make sense of this.
decided to run RatOS for some reason, despite there not being a lot to gain for a machine like this.
When I z0 outside of a print my offset is perfect. my nozzle comes just into contact with the peaks of my testured PEI bed, it is reproducible how over many times I've tried. power cycled, cold motors, hot motors, tried it all, z offset remains perfect.
the problem is that if I'm actually in a print the nozzle says it is at my first layer height of .24mm, but the nozzle itself is physically +2mm off of the bed. Mainsail says .24, if I GET_POSITION I get .24, as far as I can tell the machine truly believes the nozzle is .24mm high and not the 2+mm it is in the real world.
My superslicer profile was build from scratch off of the generic. My Orca slicer profile is the delta flyer's with a few machine specs changed. I didn't have orca even installed on this machine before, so that is as fresh as it can be. same results with both slicers.
I've asked in the discord channel dedicated to this machine (some help, but no resolution yet) and the klipper discord help (no responses at all), so I'm really hopeful someone in here can help me make sense of this.
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,070Members
Resources
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}