![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
Eddy USB on RatOS 2.1 all kinds of troubles
setupOK. I have this issue. I can't do a prime blob properly, I already managed to do a bed mesh. But when I try to start with prime blob I get an error about z move being too low. I commented out all kinds of bits and bobs to eventually get it to prime, but. I then get z-offset issues. When I recalibrate the paper-pinch method it starts floating, I recalibrate, it digs into bed. I just can't get Eddy to work semi decent .. already at the brink of switching back to pinda 
PS. I tried both BTT configs with and without z-offset ... always the same troubles ... :/ If anyone is willing to chip in, I'm more than happy to experiment before I finally teach the printer to fly
PS. I tried both BTT configs with and without z-offset ... always the same troubles ... :/ If anyone is willing to chip in, I'm more than happy to experiment before I finally teach the printer to fly
printer.cfg71.22KB
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,070Members
Resources
Recent Announcements
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}