hey Guys, im seeing an odd problem with Homing the X axis on a clean install RC4-5 this is an old printer that was homing properly on previous releases.
Checked all axis moving in right direction
checked endstops all triger properly
i can get it to home sometimes but every now and then it will throw a
"No trigger on x after full movement" error. if i reboot or restart the fw it will work fine, also if i set center kinematic position it will most likely work fine as well.
this is a Vc4 500mm hybrid
during " BEACON_RATOS_CALIBRATE" it also did something odd, went full right and started bringing Z up but the toolhead was outside the build area.