![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
New Rat Os install endtop issues
Errors⚙️Configuration
Boardsi have installed rc4 on voron 2.4, i replaced the old octopus for the new pro 723 v1.1, (for sole purpose of using RAT OS) relocated all my electronics onto a slide out, all the motors/endstops worked before i just such at the macros and needs a simpler approach. I was oing threw initial testing of everything.(before i go thew the work of making it look pretty) fiirst was x and y, x is on EBB 4 2 Gen 2 and Y is on main board, i have tested both and they fail immediately. I used my voltage meter to test the switch and it functions perfectly. i tried both a NO and NC setups and the results are the same it says endstop is already triggered. i removed the endstop and it is on wire about a foot long for testign purposes, I know the wires and switch work, i tried adding them directly to printer.cfg and that still did not help
klippy_2.log2.1MB
printer.cfg6.54KB
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,034Members
Resources
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}