![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
RatOS 2.10 RC4 - Euclid Z-Offset Fail
Errors⚙️ConfigurationHello everyone,
I had to reset my Vcore3 and installed RatOS 2.10 RC4 in the process.
The print head is equipped with a Euclid.
Retrieving, scanning, and returning the print head works so far.
Unfortunately, I cannot adjust the Z offset.
If I leave the Z-offset at 0.0 in printer.cfg, then when I start printing, there is a gap of approx. 15 mm between the nozzle and the print bed.
If I then manually correct this value to 10.0 mm in printer.cfg for testing purposes, the printer reports that I am outside the permitted range when starting.
What can I do here?
I had to reset my Vcore3 and installed RatOS 2.10 RC4 in the process.
The print head is equipped with a Euclid.
Retrieving, scanning, and returning the print head works so far.
Unfortunately, I cannot adjust the Z offset.
If I leave the Z-offset at 0.0 in printer.cfg, then when I start printing, there is a gap of approx. 15 mm between the nozzle and the print bed.
If I then manually correct this value to 10.0 mm in printer.cfg for testing purposes, the printer reports that I am outside the permitted range when starting.
What can I do here?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}