Printer: RatRig V-Core 4.0 500 IDEX
RPi 4 4GB Distro: RatOS v2.1.0-RC 2
RatOS Core: Configurator & Configuration v2.1.0-RC3-29-g6f87a747
Elecronics: Octopus 1.1 with EBB42 1.2 on T0 and EBB42 1.2.1 on T1
Started having problems with T1 disconnecting on prints. Latest error was “TMC ‘Extruder1’ GSTAT 00000001 reset=1 (Reset)”. Purchased a replacement EBB42 1.2 board that turns out to have 1.2.1 silked on the board. I can’t find any documentation that this board exists other than the KB3D listing.
I run the RatOS Configurator Setup Wizard and it will recognize the Octopus 1.1 and allows me to flash it, but doesn’t show the toolhead boards skips straight to hardware selection.
Any ideas of why this is happening and how to resolve?
Thank you.