shutdown and x motor problems. x motor

When i try to hone x or y this is qhat happens. Right. Motor only moves when x endstop is pressed.

rubber-blueOP•12/14/22, 11:00 PM

Also only left motor works until one endstop is pressed.

blacksmithforlife•12/15/22, 12:22 AM

Lowsideshort, mean you literally have a short in the wiring or you haven't seated your driver's down all the way

worthy-rose•12/15/22, 5:48 PM

or as I did - to low vref cause the problem with propper stepper/motor operation

rubber-blueOP•12/16/22, 6:31 PM

Update. Swapped tona new wire set and everything is golden

rubber-blueOP•12/16/22, 6:31 PM

Everything has tested good at this point. Will do my first test print this weekend if i cant get to it today.