![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
V-Minion Mesh help
Hey guys! I just went through the usual steps of getting a nice mesh with my new Minion.
As long as it was somehow related to one of the three screws, i was able to dial it slowly in. But now i actually don't know how to improve this anymore
I did put the Gantry in Parallel in the built process, and as far as i can see, that went okay.
I used the RR PEI Sheet for these measurements, but just for a comparison also used a Prusa Mini Satin Sheet - the zero level ofc changes quite a bit, but the basic shape stays the same with both.
Measurements all taken at 80°C set for the Heatbed.
Any advice?
As long as it was somehow related to one of the three screws, i was able to dial it slowly in. But now i actually don't know how to improve this anymore
I did put the Gantry in Parallel in the built process, and as far as i can see, that went okay.
I used the RR PEI Sheet for these measurements, but just for a comparison also used a Prusa Mini Satin Sheet - the zero level ofc changes quite a bit, but the basic shape stays the same with both.
Measurements all taken at 80°C set for the Heatbed.
Any advice?
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}