![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
MCU 'mcu' shutdown ADC out of range - first startup
"MCU 'mcu' shutdown: ADC out of range This generally occurs when a heater temperature exceeds its configured min_temp or max_temp. Once the underlying issue is corrected, use the "FIRMWARE_RESTART" command to reset the firmware, reload the config, and restart the host software. Printer is shutdown"
Fresh build, fresh installs. When I turn on the printer and head to ratos.local the error above is what I get in mainsail.
Am I right in assuming that this is likely a thermistor wiring issue? Not sure if the USB cable would cause this, pretty sure its a good cable. I'm not sure where I would configure the min/max_temp either or if thats even something one would do.
Fresh build, fresh installs. When I turn on the printer and head to ratos.local the error above is what I get in mainsail.
Am I right in assuming that this is likely a thermistor wiring issue? Not sure if the USB cable would cause this, pretty sure its a good cable. I'm not sure where I would configure the min/max_temp either or if thats even something one would do.
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,070Members
Resources
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}