RRC
Rat Rig Community [Unofficial]•2y ago
unwilling-turquoise

First Mesh hot off the press

How am I looking? Is a variance of 0.179 good enough? This is without a magnet and plate on the bed. So I guess I just need to make sure this is good enough to proceed with actually finishing the build first. 😅
No description
3 Replies
correct-apricot
correct-apricot•2y ago
that's quite good! we'll talk again when you're ready to print 😅
unwilling-turquoise
unwilling-turquoise•2y ago
Thank you!
rare-sapphire
rare-sapphire•2y ago
omg that is PERFECT....
Want results from more Discord servers?
Add your server
More Posts
Controller fan on Octopus Pro 446, config . Help pleaseHi all To increase print speed I have connected two fans to the OctoPro board. I borrowed this coZ-probe status is always triggeredHi, again. I searched the archive and found this https://discord.com/channels/582187371529764864/84The start of print seems to miss the first few millimeters of extrusionThe first bit of extrusion after the purge seems to miss a few millimeters of extrusion. Currently Iv-minion motors soundHi, I followed the instructions for inverting the pins in the stepper motors to avoid vibrations at Firmware. Bin in. Cue geht nicht...Kann mir jemand sagen warum sich die bin nicht in cue umwandelt... Installiere pi mit Netzwerk... Geinaccurate Y axisso I just finished the build phase of my 400mm v3.1 and I'm running some of the basic stuff after coNo trigger on x after full movement ?hi , this first test print for me in V-Minion, i got this message everytime , can anyone help pleasnozzle suddenly destroying sheetLast night the EVA front cage broke (one of my early ASA prints, bad layer adhesion I guess). I prin