multiple-amethyst

The circle is not standard

V-core3.1After the assembly is completed, the round hole printed after the belt calibration is non-standard and a bit elliptical. I need help,

24 Replies

fascinating-indigo•3y ago

Check if belt tension is equal, not too low, and that the pulleys are not slipping on the motor shafts.. that's the usual causes for non-round circles

multiple-amethystOP•3y ago

Is there any standard for belt tightness, such as how much hz is the best for testing

adverse-sapphire•3y ago

No, we usually hook an accelerometer to it and run the belt tightness macro. You can then get the files off your machine and test. You're looking for about matching peak height no matter what their actual height is, and more or less in the same area. Err on the side of too loose because too tight will 100% make your motors stall. If that doesnt work, you'll need to re square your machine which is a whole deal. Failing all that there is an out of square calibration procedure you can use but you should try exhausting hardware fixes first.

multiple-amethystOP•3y ago

belt tightbedd maxro,Where can I find it,Have you used the tutorial

adverse-sapphire•3y ago

If you dont see the belt tightness macro you need to enable it in settings. And I don't know any tutorial for it unfortunately

multiple-amethystOP•3y ago

Ok Solved the problem. The reason is that the x belt pulley is installed reversely Thank you

adverse-sapphire•3y ago

multiple-amethystOP•3y ago

It's a little better than before, but it hasn't been completely solved

adverse-sapphire•3y ago

What does your tightness graph look like?

multiple-amethystOP•3y ago

I have not installed adxl345, not ratos I can also measure using klipper? Here comes the adxl345 I bought. After setting the resonance value

adverse-sapphire•3y ago

You can measure with klipper but I'm not sure the procedure. Please do that and post the belt tightness graphs. It's more of an art than a science so we'll try to work on it together.

multiple-amethystOP•3y ago

The belt calibration method recommended by another brother has been completely solved. Thank you very much https://www.printables.com/model/151815-belt-tensioner-meter-9-mm-petg-prusament

Printables.com

Belt tensioner meter 9 mm, PETG Prusament by Locki | Download free ...

For 9 mm belts, print from PETG Prusament like original model | Download free 3D printable STL models

multiple-amethystOP•3y ago