Documentation error in RatOS 2-beta-1.5
HI folks,
I found a mismatch between documentation and config.
The documentation shows to connect a probe to port PB1 on a FLY SHT-42.
In the related toolboard-config-cfg this port is set to PC15,
Do we need a new picture in the docu, or is the cfg not correct?
1 Reply
Oooh, just a sec.
Yeah config is wrong, fixing..
I have a convention where i use the bltouch sensor pin for the probe pin (PC15 in this case), but i don't think it makes much sense here wiring wise, and i believe that's why i fixed it in the wiring diagram, and then subsequently forgot about fixing the config.
Fix pushed!