Homing not working

Hi, I just finished wiring my new core 3.1 and installed the firmware and ratOS. If I login and tap the X homing button, the bed moves down maybe 10mm and X moves a short distance and then stops. The octopus 1.1 shows some red leds and one green near the end stops. I checked the wiring - I planned not to use endstops but wired them anyway just to try if that would help - but did not. What works be the right sequence to check the printer? Cheers, BJF
1 Reply
sherbs
sherbs2y ago
You can see and test the state of your x & y endstops in the gui... I'd start there and make sure the board is getting proper state info
Want results from more Discord servers?
Add your server