RRC
Rat Rig Community [Unofficial]•16mo ago
fascinating-indigo

Flipped Y axis

Hello everyone, anyone encountered something like this? I've just build pretty stock V-Minion. It homes fine. But prints are filipped on the Y axis 😦
No description
3 Replies
suitable-rose
suitable-rose•16mo ago
you can just set !<pin> on whatever stepper motor to flip it. in the printer.config
fascinating-indigo
fascinating-indigo•16mo ago
But it means that i need to move an endstop. But endstop is at it's designated place. Am I right? And Homing works good. So I have no idea what's wrong
suitable-rose
suitable-rose•16mo ago
I don't think so... I'm not sure tho
Want results from more Discord servers?
Add your server
More Posts
"Druckfehler" -> Nozzlegröße als Ursache?Hallo, liegt das Unsaubere Erscheinungsbild an dem 0,6mm Nozzle oder hat das eine andere Ursache. PASuperslicer EinstellungenHallo bin vor paar Wochen auf den Superslicer umgestiegen die Drucke von ASA und PETG sehen super auPause Print: Move Out of Range (Tool-Changer)Hi, I've encountered this problem a few times before, but never knew what the cause was. Now I'm relFysetc MINI12864 and Octopus 1.1Info for a future victim of MINI12864 RGB from Fysetc and Octopus 1.1: if you see a blank screen witHow do I get the klipper log?I tried ssh into pi but didnt find it.Extruder reset Temp after starting printUsually I turn my printer on, then depending the filament heat up my bed,and nozzle. While im doing Holes in first layer..Any idea as to what setting I can tweak to resolve the holes in my first layer test print?Changed layoutHi I my klipper screen looked like the first picture until i reloaded it once and it completely chanV-Minion Y axis chattering, not homingHi all, my V-Minion has been flawless since I got the firmware to load properly (thanks for that!) BVCore 3.1 resonance on horizontal movesMy newly built 3.1 doesn't seem to like horizontal moves, but seems much happier on diagonals (I jus