![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
Z-TILT-ADJUST fails with weird movement
After a slight rebuild of my VCore 3.0 400, I cannot get the Z_TILT_ADJUST to work.
Printer.cfg is attached. Printer homes fine, and I can manually move to all the [points] specified in the [z_tilt] section. As you can see in the video, it moves to the first point fine, but after that some weird stepper sound and it moves off the plate.
Console output as follows:
20:10:22 No trigger on probe after full movement
20:10:14 probe at 60.000,60.000 is z=-0.300938
20:10:09 Z_TILT_ADJUST
Please help. I have not changed my config from when my printer was working fine before. Only had to do some rewiring after a blob-of-death, and also upgraded to the latest EVA
Cheers
Printer.cfg is attached. Printer homes fine, and I can manually move to all the [points] specified in the [z_tilt] section. As you can see in the video, it moves to the first point fine, but after that some weird stepper sound and it moves off the plate.
Console output as follows:
20:10:22 No trigger on probe after full movement
20:10:14 probe at 60.000,60.000 is z=-0.300938
20:10:09 Z_TILT_ADJUST
Please help. I have not changed my config from when my printer was working fine before. Only had to do some rewiring after a blob-of-death, and also upgraded to the latest EVA
Cheers
printer.cfg12.94KB
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}