Belt Erosion
Hey all, I was disassembling my Vcore 3.1 500 and found that the belts had been pretty horribly eroded. See pictures. What do you think could cause this? I am guessing the belts were way too tight.
4 Replies
Probably miss aligned belts rubbing against the flanges or other parts
As BSFL. Check the belts for damage. Should be pretty noticeable
Ill be replacing the belts, i will be working on it this week, i imagine that the issue was poorly aligned gears and printed parts
I was struggling with the same problem. With regards to the pulley don’t use the ratrig instructions.
Put them on motors without tightening the grub screws, move the belts to see how they align and then tighten he screws