Z Tilt always failing: Probed points range is increasing
Hi. I've just finished with the assembly of a V-Core 3.1 300 (standard kit, everything bought from RatRig store) and I haven't been able to get the Z Tilt working consistently.
A couple of times it worked and seemed to be fine, but upon starting a print and checking again Z tilt it started failing.
I have the standard V Core 3.1 printer cfg in Klipper, with minor adjustments to the Super Pinda probe z offset.
I'm a bit lost on this. What should I start checking for this?
Thanks! 😄
2 Replies
Check with Stepper_buzz that they are connected to the correct ports. I had inverted a couple and had a simular problem. Z1 front left Z Rear and Z2 front right if i remember correctly.
Have you checked the motor directions as well?
https://os.ratrig.com/docs/configuration#verify-stepper-directions
Make sure all Z-steppers are moving in the right direction.