pin PB3 is reserved for spi3
"pin PB3 is reserved for spi3"
How can I safely use these pins for something not the adxl? So far it looks like I need to override the
spi_bus
to something else from the octopus.cfg
I use a pi pico and adxl connected to the octopus via usb so changing these values shouldn't affect me I believe1 Reply
multiple-amethyst•2y ago
I ended up using J70 for the Orbiter Filament Sensor. The 5v, GND, PA9, and PA10
Since the guide says the use the BLTouch pins but that's where the pinda is at