![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
Z-tilt working but bed wonky
Okay so I run z-tilt and it works fine corrects to .005 ish so klipper says. But you can look at the printer and see the bed is obviously skewed. In fact if I were to run a bed mesh toward the back left it would fail at the klicky probe triggers before it’s in position to probe. V-core 3.1 - 500 and it is consistent.everything measures fine.
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,070Members
Resources
Recent Announcements
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}