Topics

Rat Rig Community [Unofficial]•15mo ago

conscious-sapphire

New Ratrig 400mm setup Octopus 1.1, heat bet not heating up

It looks like everything is working, green light on the octo when I turn up the heat. Red light on the relay. But it is not heating. Anyone run into this?

5 Replies

blacksmithforlife•15mo ago

Post a picture of your wiring That's your problem you didn't wire the SSR/bed correctly

conscious-sapphire•15mo ago

Ok thanks. I'm not sure what is wrong though. I just double checked this

No description

conscious-sapphire•15mo ago

Oh. It's a relay. Duh. Thanks

blacksmithforlife•15mo ago

See the pinned message in #general-electronics

conscious-sapphire•15mo ago

Thanks!

Rat Rig Community [Unofficial]Join

12KMembers

View on Discord

Want results from more Discord servers?

Add your server

More Posts

Phaetus Rapido UHF + Volcano CHT Nozzle + LGX LiteMy setup seems to skipping extrusion steps at only around 15 mm³/s PLA+ at 210-225 did the same thi V3.1 Rear Z Axis -- Sufficient to Just be Parallel?I got my rear Z axis parallel to the two front ones pretty much dead on. But the entire bar is sligh resonance spikes on new carriageI have fitted a new modded printhead into my v-core 3 400 and have been trying to tension belts prop Toolboard: 4028 Fan wired correctly but behaving inverted.Basically the title. Ive tried all manners of trying to the the pin to invert in klipper and nothi V Minion Z BandingHello. Just got my Minion running recently and I’m having a rough time getting rid of z banding. It end stop connector may have been reversedWhat symptoms do you have when you may have installed the end stop connectors with the wrong polarit RatOS nach Stromausfall fehlerhaftGuten Morgen zusammen, leider gab es bei uns letzte Nacht einen Stromausfall und heute morgen zeigt V-Minion bed tilt?Hello. Not really sure what to make of this. Gantry is level and the frame is square but the bed see What's causing these "hair" strings?I've played around with different retraction tests but I can't get rid of this. What am I missing?HelpHello everyone, I have never really printed anything this tall before. So im not sure why this is ha