RRC
foreign-sapphire
Possible faulty probe?
I suddenly get “No trigger on probe after full movement” error when doing a mesh calibration, but it homes(G28) perfectly fine.
Any help will be much appreciated!
3 Replies
foreign-sapphireOP•3y ago
The printer is a V-minion.
foreign-sapphire•3y ago
does it fail in the same area ( within 1-2 probe points)?
if yes you can increase sample retract distance and try again
foreign-sapphireOP•3y ago
I did it. It successfully finishes the mesh, but it’s been acting up again and it’s not triggering