VCORE 3.1 400MM BED MESH - CONFIRMATION OF WHERE TO LIFT
My back corner is fairly high and i have a small dip in the middle front. Could someday kindly confirm the best route to level out. Shall I rectify 'D' or balance out with the other corners. Thanks for your time.
10 Replies
rare-sapphire•3y ago
so the max deviation is about 0.1mm? that's ungodly good for the size of printer, you can try and tinker with the frame here and there, but it's not likely to get any better than that 😛
national-goldOP•3y ago
isnt the max deviation here 0.4 ish?
rare-sapphire•3y ago
might be, the formatting isn't what i am used to
my 500 has 1.2mm deviation at the worst...so anything below 1mm is great 😄
national-goldOP•3y ago
at the lowest point its -0.132 and the highest point is 0.363
B UP would drop D. but B up higher than A will mess up other stuff.
national-goldOP•3y ago
nice @ptegler. Thank you. Ive now reached this point by bringing A down and a touch of B up. Should i keep going, id like to ideally bring the deviation to sub 0.2
national-goldOP•3y ago
national-goldOP•3y ago
This will do i guess FALSE READ ^^^^^
national-goldOP•3y ago
I knew it was to good to be true. Not sure what happened but im back to this after whacking my enclosure on. Shall i just rebuild ?
national-goldOP•3y ago
at a lost as to where to pull up now
Ill bring down A and see wether thats sorts out C and then ill tackle B and D i guess