First few layers of prints are curved
After getting though a bunch of initial calibration and tuning, I began printing some parts, but they all had a similar flaw. The first few layers are not flat and curve upwards toward the edges. It isn't severe, but it is noticeable and enough that parts that are supposed to fit together need some sanding or filing. Any common reasons for this?
Some info about my setup:
Duramic 3D PETG Black
250/80
no enclosure
V-Core 3.1 400
SuperSlicer
I'd upload my printer.cfg, but I'm in the middle of rebuilding it with ASA parts and Enclosure 2.0.
2 Replies