![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
Z Offset
Any ideas on what could be up with my z offset? It's been fine for months but today before a print the nozzle gouged through PEI sheet. When I checked Z-Offset in printer config it read 0. Performing a probe_calibrate and saving will not update the offset in printer config and it stays at 0.
#z_offset: 0.0 # Adjust this to fit your setup
Z offset gets commented out as above every time I try to save the value manually. Probe is working fine and allowing me to set z-tilt.
Inductive/Capacitive probe
[include RatOS/z-probe/probe.cfg]Inductive probe configuration
[probe]#z_offset: 0.0 # Adjust this to fit your setup
Z offset gets commented out as above every time I try to save the value manually. Probe is working fine and allowing me to set z-tilt.
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}