Rat Rig Community [Unofficial]RRC[
Rat Rig Community [Unofficial]•3y ago•
10 replies
CoffeeSquirel

Printer fails to probe a bed mesh when starting a print

Hey, I have a problem with my V-Minion, whenever it goes to do a bed mesh, it manages to probe some points, but suddenly plunges the nozzle into the bed (thank you for that spider coupling). The Mainsail console spits out this:

10:11 AM
G91
G1 Z+25 F1500
10:11 AM
G91
G1 Z+25 F1500
10:11 AM
Extrude below minimum temp
10:11 AM
Extrude below minimum temp
See the 'min_extrude_temp' config option for details
10:11 AM
Extrude below minimum temp
10:11 AM
Extrude below minimum temp
See the 'min_extrude_temp' config option for details
10:11 AM
Extrude below minimum temp
10:11 AM
Extrude below minimum temp
See the 'min_extrude_temp' config option for details
10:11 AM
Extrude below minimum temp
10:11 AM
Extrude below minimum temp
See the 'min_extrude_temp' config option for details
10:11 AM
echo: Cleaning up...
10:11 AM
No trigger on probe after full movement
10:11 AM
No trigger on probe after full movement
10:11 AM
No trigger on probe after full movement

Any ideas what may cause this? The sample retract distance is 3mm
Was this page helpful?