Where is "docs/Config_reference.md" ?
RatRig V-Core 3.1 500, Octopus Pro, Raspberry Pi 3B+
New problem, just started today. Bed is warm to touch, but not hot enough. I'm getting the following message:
"Klipper reports: SHUTDOWN
Heater heater_bed not heating at expected rate
See the 'verify_heater' section in docs/Config_Reference.md
for the parameters that control this check."
Please help? Thank you very much!
2 Replies
It is from the klipper documentation
https://www.klipper3d.org/Config_checks.html#verify-heaters
eastern-cyan•2y ago
Thank you, Mr. Blacksmithforlife us!