RRC
Rat Rig Community [Unofficial]•14mo ago
unwilling-turquoise

Problems after installing BTT42

Followed the steps for btt42 wiring and flashed the mcu (flash was confirmed), getting this error on boot, need someone to look over my .cfg to see if I've uncommented the proper lines. TIA
No description

printer.cfg

4 Replies
miklschmidt
miklschmidt•14mo ago
parameters has to be under a [section] header, just like the error says. Uncomment line 283.
unwilling-turquoise
unwilling-turquoise•14mo ago
Got it, but now this
No description
unwilling-turquoise
unwilling-turquoise•14mo ago
Got it.... Had resonance testing and probe points that needed to be uncommeneted
fascinating-indigo
fascinating-indigo•14mo ago
Team, I'm starting a new post off of this thread. Experiencing the same problem and tried what was suggested here.
Want results from more Discord servers?
Add your server
More Posts
Part cooling fan running full speed at 0% and homing issuesI have the delta PWM fan set up as close as I can tell to what douzuki says in their build instructiis it normal the the 4028 fan can't run under 40% ishi have the fan wire up like the guide but the fan can run below 30-40% duty is this normal and if noz tilt issueSo I think I almost have my printer fixed except 1 issue. Its kinda odd, but here is what is happen4028 Lüfter läuft nichtHabe gerade RatOS 2.0 auf meinem VC300 eingerichtet und eigentlich die gleiche config übernommen wiebl touch not getting consistent measurements since updating to ratos v2Yesterday i upgraded from ratos v1 to v2 (i know, i wasnt even aware that it was a thing lol). Now mHoming Position Error after RatOS 2.0 Install (Sensorless Homing)Hey. I have absolutely no idea what might be the Problem. Did a fresh install of RatOS2.0 on my VC30How do I improve from this test?I've printed this tuning test on my VCore 3.1 400 with a 0.6mm nozzle, in PLA at 215c through a RapiV minion Eva 3.0 problemswhen i start a print on my v minion with sensorless homing it doesnt print in the middle of the bed Klipper not running after V-Core-3 config is installedMy printer has been running great for a couple of months, but something has gone wrong. I keep gettix endstop cableso in trying to find ongoing issues, i noticed the cable on the x endstop is hot, I just unplugged i