![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=48){kind=icon}
RatRig v-core 3.1 SuperPinda Always Triggered
Just finishing v-core 3.1 500 build and the SuperPinda is always reading as Triggered with the recommended configuration of "pin: ^probe_pin # For NPN NC probes such as the Super Pinda / Vinda / SupCR / Decoprobe probes.". Tried inverting the config with pin: ^!probe_pin which switched it to always open, but it does not trigger when the probe is brought close (/touching) the bed.
The probe came with the ratrig kit, and has slightly different color wires (a black instead of grey plus the brown and blue wires) than shown on the ratrig configuration picture for the BigTreeTech Octopus Pro. I have them wired as black as pin 1, blue as pin 2 and brown as pin 4f on the diagram. I am not sure if this is a) a wiring problem, b) a configuration problem or c) a broken super pinda.
Does anyone have hints on troubleshooting this?
The probe came with the ratrig kit, and has slightly different color wires (a black instead of grey plus the brown and blue wires) than shown on the ratrig configuration picture for the BigTreeTech Octopus Pro. I have them wired as black as pin 1, blue as pin 2 and brown as pin 4f on the diagram. I am not sure if this is a) a wiring problem, b) a configuration problem or c) a broken super pinda.
Does anyone have hints on troubleshooting this?
![Rat Rig Community [Unofficial] banner](https://cdn.discordapp.com/banners/582187371529764864/4ee3e42e227d6aac26f048a3e69d5924.webp?size=480)
The #1 unofficial Rat Rig Community on Discord!
14,070Members
Resources
Similar Threads
Was this page helpful?
![Rat Rig Community [Unofficial]](https://cdn.discordapp.com/icons/582187371529764864/08375bea6b5b9088b6d4cfc2b6e25fba.webp?size=16){kind=icon}